The main components of the aluminum wafer uncoiling and blanking production line are: loading trolley, uncoiling machine, leveling machine, feeder, swing unit, special closed single-point mechanical press, quick die changing device, palletizing unit, scrap shear Cutting, hydraulic system, electrical control system, etc.

Technical characteristics of production line:
1. Fully numerically controlled, the production line should start from the unwinding of the coil, until the entire roll of material is blanked, no manual contact with any materials is needed, no adjustments are needed, and the potential safety hazards of ordinary punches are basically eliminated. Hidden product quality.
2. The line can directly use the coil to produce wafers without the need for slitting and cross-cutting of the coil, which reduces the production process, reduces the cost of production, and reduces the possibility of damaging the surface of the coil. The disc is guaranteed to be free of oil and scratches.
3. This line makes full use of the width of the coil and uses high-precision servo motor drive system control to minimize the wafer spacing and the distance from the wafer to the material edge, radically reduce the amount of waste, and make the raw material utilization rate reach 80%. the above.
4. Production speed can reach 40-55 tablets per minute, which improves production efficiency.
5. Due to the use of a modular mold design, when converting wafer production specifications, the conversion time can be reduced to less than 15 minutes. The diameter of wafers that can be produced ranges from 85 mm to 750 mm.
6. Advanced unwinding system, six-level leveler, high rigid mechanical press, automatic palletizing system, etc., ensure the high quality of wafer products

Leave a Reply

Your email address will not be published. Required fields are marked *