Automatic Aluminum circle blanking production line processing
Aluminum circle uncoiling blanking production line is mainly composed of: feeding trolley, uncoiling machine, leveling machine, feeder, swing unit, special straight side single-point mechanical press, rapid mold change device, stacking unit, scrap shear, hydraulic system, electrical control system, etc.
Technical features of production line:
- CNC is fully automatic. The production line should start from the unwinding of the rolling materials until the blanking of the whole rolling materials is completed.
- This line can use the coil material to directly produce wafers, which does not need the slitting and crosscutting treatment of the coil material, which reduces the production process, reduces the production cost, and reduces the possibility of damaging the coil material surface. The Circle produced are guaranteed to be free of oil stains and scratches.
- This line makes full use of the width of the coil and adopts a high-precision servo motor drive system to control it, so as to minimize the wafer spacing and the distance from the circles to the edge of the material, fundamentally reduce the amount of waste, and make the utilization rate of raw materials reach more than 80%.
- The production speed can reach 40-55 pieces per minute, which improves the production efficiency.
- Due to the modular mold design, the conversion time can be reduced to less than 15 minutes when the circle production specifications are converted.Wafers can be manufactured in diameters ranging from 85 mm to 750 mm.
- Advanced uncoiling system, six-fold leveling machine, high-rigidity mechanical press, automatic stacking system, etc. ensure the high quality of circle products.
Production line technical parameters:
Roll width (mm) : 500-1250, 800-1400, 1000-1600
Roll thickness (mm) : 0.4-3.0, 1.0-6.0
Roll weight (kg) : 8000,10000
Blanking diameter (mm) : 85-660, 85-750, 100-900
Blanking times (SPM) : 40-55
Press nominal pressure (kN) : 1250,1600,2000,2500